Pages: 1 2 [3]   Go Down

Author Topic: Any new 17" printer rumours?  (Read 22448 times)

Dale_Cotton

  • Sr. Member
  • ****
  • Offline Offline
  • Posts: 580
    • http://daystarvisions.com
Any new 17" printer rumours?
« Reply #40 on: February 25, 2008, 09:51:15 AM »

Phil Brown wrote:
Quote
If you have carts showing as low (giving a low warning) and you get banding and see losses in the nozzle checks and can't revover with a clean, I'd suggest changing the carts showing as low as they may be running out. You should see that before you run so dry as to be any real problem.
Thanks! I had been planning simply to replace carts from the initial set as they dropped down to may the 1/8th level. Good to know I can push a little further.
Logged

Farmer

  • Sr. Member
  • ****
  • Offline Offline
  • Posts: 1735
Any new 17" printer rumours?
« Reply #41 on: February 25, 2008, 03:46:13 PM »

Quote
Phil Brown wrote:

Thanks! I had been planning simply to replace carts from the initial set as they dropped down to may the 1/8th level. Good to know I can push a little further.
[a href=\"index.php?act=findpost&pid=177219\"][{POST_SNAPBACK}][/a]

Under normal circumstances, of course, you wait until they say they're empty but I reckon you were on the right track to be wary of them this time around due to the interupted initialisation.
Logged
Phil Brown
Pages: 1 2 [3]   Go Up