Pages: [1]   Go Down

Author Topic: Z3100 Gloss enhancer scuffs very easily  (Read 1614 times)

Harry Carpenter

  • Jr. Member
  • **
  • Offline Offline
  • Posts: 52
Z3100 Gloss enhancer scuffs very easily
« on: December 06, 2007, 03:30:11 pm »

I am having an issue with inserting z3100 8x6 prints in card mounts.
I have to wrap the print in card and then slide it in then remove the wrap by sliding it out. Unless I do this every print is getting marked or scratched when inserting it. Is there a dry time for GE or am I expecting too much. My feeling is that the finished prints are not suitable for handling as they mark too easily.
Logged

rdonson

  • Sr. Member
  • ****
  • Offline Offline
  • Posts: 3263
Z3100 Gloss enhancer scuffs very easily
« Reply #1 on: December 06, 2007, 06:38:56 pm »

Quote
I am having an issue with inserting z3100 8x6 prints in card mounts.
I have to wrap the print in card and then slide it in then remove the wrap by sliding it out. Unless I do this every print is getting marked or scratched when inserting it. Is there a dry time for GE or am I expecting too much. My feeling is that the finished prints are not suitable for handling as they mark too easily.
[a href=\"index.php?act=findpost&pid=158770\"][{POST_SNAPBACK}][/a]

My experiences have been that GE is somewhat delicate.  Easily scratched with a finger nail.
Logged
Regards,
Ron
Pages: [1]   Go Up