Perhaps this has been discused before and if so I would appreciate being directed to the thread. I have a 24" Z3100 for about 5 months and until recently the only problems I have had with skew were with sheet paper which is easily corrected.
However recently I am having a serious problem with rolls - paper and canvas. Sometimes it takes me as long as 15 - 20 minutes before I can get a roll accepted by the printer. Yesterday I used canvas (Fredrix 901) and it took me over 30 minutes before it was accepted. BTW, the results were exquisite.
In any event, if there are any suggestions as to procedure or other thoughts (does the machine need service) I would appreciate help. Thanks,
Harris
