I regularly dry mount luster and glossy prints produced on an Epson 7800 to Bainbridge Artcare Restore foamboards.
The dry mount adhesive is on the board so one no longer needs to mess with tissue and tacking irons. The temperature recommendation is low, only 150 deg F, and time is short. I have had no problems at all. I've mounted prints up to 24 x 32 inches in sections. I place clean 4 ply mat board on top of release paper which is in contact with the inket print surface. For sectional mounting be sure the 4 ply top mat board overhangs several inches to avoid creases. My time in press is only 35 sec, you may be able to use even less time. If you go this route be sure to ask Bainbridge for the free temperature calibration strips (available from their website). Dry mounting press temperatures are often vastly different than the knob setting.