Pages: [1]   Go Down

Author Topic: Moab Entrada Surface difference  (Read 4496 times)

chriscor

  • Newbie
  • *
  • Offline Offline
  • Posts: 38
Moab Entrada Surface difference
« on: July 31, 2006, 04:56:30 pm »

Anybody here using Moab Entrada paper notice a difference in the texture of the surface between the 300 and 190 weight paper?
I just switched from printing on UltraSmooth to Moab because I needed a paper with a whiter base.  I proofed my images on the 190 weight Moab paper and I'm printing the finals on the 300 weight paper.  There's a noticeable difference in the surface smoothness of the two papers.  Has anyone else experienced this?

Thanks
Chris
Logged

chriscor

  • Newbie
  • *
  • Offline Offline
  • Posts: 38
Moab Entrada Surface difference
« Reply #1 on: August 01, 2006, 06:56:19 pm »

The answer is yes.  I just spoke with someone at Moab and they confirmed that there is a surface difference between the papers.  Apparently  thicker papers have a rougher texture.   On the images I'm printing it takes on the appearance of increased film grain.
Logged

JeffKohn

  • Sr. Member
  • ****
  • Offline Offline
  • Posts: 1668
    • http://jeffk-photo.typepad.com
Moab Entrada Surface difference
« Reply #2 on: August 02, 2006, 01:21:57 am »

Your post prompted me to perform a similar comparision with Hahnemuhle Photo Rag, I which I just recently bought 13x19 in 308gsm and 8.5x11 in the lighter weight. Same thing, the thicker paper has a bit more texture. I don't find it objectionable, though, in fact I prefer the texture of the heavier paper.
Logged
Jeff Kohn
[url=http://ww

esantos

  • Newbie
  • *
  • Offline Offline
  • Posts: 9
Moab Entrada Surface difference
« Reply #3 on: August 02, 2006, 12:12:22 pm »

Not to steer off topic but has anyone experienced surface flaking with Entrada? I tried a few sample sheets about two years ago and I decided not to buy this paper because it would flake quite a bit. I have never had this problem with Ultrasmooth and have been using it since. Has this been corrected by Moab?
Logged

StephenS

  • Newbie
  • *
  • Offline Offline
  • Posts: 29
Moab Entrada Surface difference
« Reply #4 on: August 02, 2006, 12:51:31 pm »

yes, a fair degree of surface flaking if you don't brush the surface prior to printing. I haven't checked some older prints yet to see if the surface has flaked any more  but I will at my first opportunity.
Logged

abiggs

  • Sr. Member
  • ****
  • Offline Offline
  • Posts: 555
    • http://www.andybiggs.com
Moab Entrada Surface difference
« Reply #5 on: August 02, 2006, 01:29:36 pm »

Quote
yes, a fair degree of surface flaking if you don't brush the surface prior to printing. I haven't checked some older prints yet to see if the surface has flaked any more  but I will at my first opportunity.
[a href=\"index.php?act=findpost&pid=72405\"][{POST_SNAPBACK}][/a]

All fine art matte papers need to be brushed prior to use............
Logged
Andy Biggs
[url=http://www.andybiggs.com
Pages: [1]   Go Up