Z3200 44.1 Error

[namartinnz]

Hi everyone

I've got a 44.1 error on my Z3200. If it's the same code as the Z3100 I assume it's something to do with the fan or printmech PCA? Are these relatively easy to fix?

Cheers
Neal

** Update **

I Decided to open the printer up and found a gunked up fan. A quick whirl, wipe down and wiggle some wires and it's all good again for the time being. I'll likely need a replacement at some stage.

[Mark Lindquist]

Here's how to fix your fan:

Replacing the Z3200 Fan

Might as well start ordering the fan -it's inevitable.

Not too bad if you take it slow and easy.

[kers]

Here's how to fix your fan:

Replacing the Z3200 Fan

Might as well start ordering the fan -it's inevitable.

Not too bad if you take it slow and easy.

Mark you have become the Z- repair man!

With my Z3100 the first thing that broke down was the fan... but it is easy to replace.
A save start for getting to know the machine.

[namartinnz]

Mark

This was the fan at the other end beside the ink station and would be very easy to replace. Fingers crossed the power supply fan won't need fixing for a long time

[garyfcampbell]

that looks bad from the ink

[namartinnz]

Yes I think the service station will need to be replaced/cleaned up soon. When I put the rhs cover back on yesterday, ink started pouring out of it. Overflow I think and was likely in the cover but I didn't see it originally. I have my old z3100 station so will look if I can use it as a future replacement