Gang,
Quick advice. I'm trying to pick-up a used 63" Fletcher cutter tomorrow. It is an older one, I think a 8400.
How much of the cutter can be disassembled? I know the right arm comes off. I looked at the manual but it appears the left arm and alonum triangle can't be removed?
My concern is I have a 4 door Jeep with a hatchback. The back seats go down and I know they will fit a 36*48" board flat. I hope the top of the Fletcher can fit through the front seats. Im not sure of the left arm if left attached will fit.
It's a good price I hope at $195. I need it mainly for foam core and 3-5mm sintra.
Just need some advice.
Thanks
Maxi