Pages: [1]   Go Down

Author Topic: Epson 9900 Service Code - D130  (Read 1223 times)

Garnick

  • Sr. Member
  • ****
  • Offline Offline
  • Posts: 1229
Epson 9900 Service Code - D130
« on: August 14, 2015, 12:10:52 pm »

Has anyone seen this code and what is it in reference to?  I have seen it a couple of times when entering Service Mode and thought perhaps I hadn't held down all of the necessary keys as firmly as needed.  The information included suggests a restart, and if that doesn't work, a Service Call.  The restart has always worked, so far.  Recently I saw it after starting in Standard Mode following a K ink swap in Service Mode.  Any ideas?

Gary
Logged
Gary N.
"My memory isn't what it used to be. As a matter of fact it never was." (gan)

cybis

  • Sr. Member
  • ****
  • Offline Offline
  • Posts: 283
    • http://www.lucbusquin.com
Re: Epson 9900 Service Code - D130
« Reply #1 on: August 14, 2015, 11:00:58 pm »

Hi Gary, I've never encountered that error code but the service manual says:

"This is a debug error that occurs at product development. In principle, it does not occur for mass-produced products; however, it might occur due to unexpected causes such as external noises.

1. Restart the printer. If the error does not occur, observe the printer for recurrence.
2. Re-install the firmware.
3. Replace the Main Board Assy."

Also I would try unplugging the printer for a minute and see if the error comes back.
« Last Edit: August 14, 2015, 11:16:06 pm by cybis »
Logged
Pages: [1]   Go Up