Luminous Landscape Forum
Raw & Post Processing, Printing => Adobe Lightroom Q&A => Topic started by: mdijb on June 10, 2013, 07:39:25 pm
-
THis link describes a disturbing bug in LR5
http://regex.info/blog/2013-06-10/2268
MDIJB
-
I hit a variation on it immediately after upgrading. Somehow my film strip selection got out of sync with my grid view selection in normal library mode (not the publish collection). When I would switch from Library to Develop I'd get the image I had selected in the film strip, not the grid view. Whatever I selected in grid didn't get reflected in film strip and vice versa.
Thankfully shutting down Lightroom and running it again resolved it.
Neil
-
Jeffrey did an update on that post:
http://regex.info/blog/2013-06-12/2270
Mike.
-
I have sometimes noticed a similar bug in LR 4.x, but in a less dangerous situation, so I never reported it.
I have found that sometimes in the print module, if I have printed a few prints and then decide to print some different ones, making a new selection in the film strip does NOT get understood by the print module. Often, the previous set of images is still selected in the Print module, while a contradictory set is selected in the filmstrip.
Since I always loop through the print previews before printing, this has never caused me to lose an image. But I've never played with the Publish module.
In any case, I hope they fix it soon.
Eric M.