Luminous Landscape Forum
Raw & Post Processing, Printing => Printing: Printers, Papers and Inks => Topic started by: dseelig on April 25, 2013, 08:29:34 pm
-
My 3880 is leaving some ink along the top of the prints if you are looking at a horizontal print on the top right hand side of the print just like a little ink about the last inch of the print on the border a few millimeters wide. Where do I clean up?
Thanks David
-
Maybe it's as simple as the paper has a slight curl and/or is 'hanging' on exit
adjust platen gap
adjust paper thickness setting in driver
pull out the output tray so the paper is supported as it exits the printer.
-
The paper is 8.5 by 11 exhibition fiber no curl at all anyone else? Thanks Though David
-
The paper is 8.5 by 11 exhibition fiber no curl at all anyone else? Thanks Though David
13 mil paper needs paper thickness set to '4'
If you have print area set to max. Trailing edge printing degrades
Suggest wider platen gap
-
thanks did the trick
david