Luminous Landscape Forum
Raw & Post Processing, Printing => Capture One Q&A => Topic started by: marcmccalmont on October 26, 2012, 10:37:08 pm
-
I can't figure out how to set the source so that CO7 will process my files?
Marc
-
rebooted the computer Fixed!
Marc
-
Hi Marc,
Once on a flight they rebooted the airplane. Odd experience. Unfortunately it did not help ;-)
Best regards
Erik
rebooted the computer Fixed!
Marc
-
Once on a flight they rebooted the airplane. Odd experience. Unfortunately it did not help ;-)
Ha, I also had that happening once, it was the best that Boeing/Seattle in an emergency call could come up with, a cold reboot. Fortunately we were still on the ground :) After switching off all electrical power, they hoped that the faulty 2nd autopilot relais would initialize okay, and it did.
Cheers,
Bart
-
Once I was flying a Dornier regional jet and rebooted it on the ground, never had to in the air!
In my current plane the 777 everything is electric even the flight controls!
Marc
-
Hi,
Sorry, I should have been more precise. What happened was that we taxied to the runway, where they decided to reboot the plane. They still got a bad indication after reboot, so we went back to the gate for an hour or so. So they didn't reboot the airplane in flight.
Best regards
Erik
Ha, I also had that happening once, it was the best that Boeing/Seattle in an emergency call could come up with, a cold reboot. Fortunately we were still on the ground :) After switching off all electrical power, they hoped that the faulty 2nd autopilot relais would initialize okay, and it did.
Cheers,
Bart
-
One thing to remember is that if a file has been opened previously with Capture 6, and you open it with 7, the default engine will be Capture 6. On a new file never opened by Capture 7, the engine defaults to 7. If you have a file that is showing the engine as Capture 6, you can change it in the preferences section (windows version).
Paul
-
Back to C1 v7. I can't process any images either. I've restarted the computer but its not helping. Any other ideas?
-
Okay, I added the batch tab to my tool tabs and this problem is resolved.