Luminous Landscape Forum
Raw & Post Processing, Printing => Printing: Printers, Papers and Inks => Topic started by: Didymus on October 05, 2012, 03:33:24 pm
-
When I began stretching canvas I used Eco Print Shield. I am now using Timeless and I can't seem to get the hang of it. I've been successful but it's hit and miss. Sometimes I still see white after it has dried. I'm assuming it is because, unlike Eco, Timeless only calls for one coat and no dilution. I'm really trying to work it in a lot but maybe it's not enough. Does anyone have any advice, experience or preference?
Thanks,
Tommy
-
Sometimes I get little white/lighter patches that remain after drying if I've used too much coating.
For larger prints I apply 2 coats: the first is worked in a lot and I don't care much if I see lines or bubbles. The second coat I apply more gently and smoothly, trying to avoid bubbles and roller lines. It is this second coat that is key: too much Timeless on the roller and I get the white patches. Hard to say how much is enough - kind of an experience thing.
For smaller prints I just use a saturated roller, work in the coating and then roll progressively lighter and lighter to smooth off the coating. Sometimes I use a bulb blower to pop unruly bubbles.
-
Very helpful, thank you.
-
I have found that Timeless is not a product that can be used on all canvas. I would be careful. I have ruined about 6' of canvas trying to roll timeless. Now I only use spray Print Shield, once before streching and once again after. So far very satisfactory results. Check back in 20 years for a report.
David
-
I'm using Lyve.
-
I'm told that Timeless was designed for Lyvle and can't be rolled on gloss canvas, only sprayed. But sprayed and rolled on matt canvas.
Best of luck.
David
-
Tommy,
Just curious as to why you moved away from Eco Print Shield?
Gary
-
Since Epson switched to the exhibition canvas I decided to go with BC Lyve. My gallon of Eco was out shortly after that and I decided to get Timeless to go along with the Lyve canvas. I just thought it made sense to use the two Breathing Color products together.
-
FWIW, I've never used Timeless but I have used diluted Glamour II and the generic ready to spray coatings from Lexjet. I use the prior version of the current Wagner 518080 HLVP sprayer. I tried rolling coatings on canvas early on and quickly gave it up. Unless you're trying to create a textured surface, in my opinion, spraying is the only way to create a professional, uniform coating.
My technique is pretty simple. I place the printed canvas on a large flat surface, outdoors, and apply the spray coating back and forth in much the same way an autobody painter applies paint. I start the spray before reaching the edge of the canvas, to avoid drips, and overlap passes, all in one direction. Instead of waiting for that coat to dry, I immediately start passes at 90 degrees to the first pass. When I have finished the canvas has a slightly milky look that dries clear. If there are bubbles in the coating I use the pressure of the compressed air that comes out of the sprayer to level the bubbles. I spray at about 8-12 inches from the canvas surface.
It's really pretty easy once you do it a few times and the results are predictable.