Luminous Landscape Forum
Raw & Post Processing, Printing => Printing: Printers, Papers and Inks => Topic started by: Charles Gast on December 29, 2007, 04:48:16 pm
-
I turned off the skew check on this z3100 since it won't let me print within 9mm of the sheet edge anyway. Now the print driver thinks the sheet is smaller than the size I am telling it and says it is really 8 inch by 33 inch!
When I go ahead and print it stops printing 4 cm from the right edge leaving the print unfinished. How can this printer with so many sensors and a computer on board be so stupid?
If anyone has a solution please let me know.