Luminous Landscape Forum
Raw & Post Processing, Printing => Colour Management => Topic started by: alecdann on April 18, 2018, 10:31:34 pm
-
When I create a patch set in i1Profiler with the intent of printing it, I save it so I can load it the next day when I'm doing the actual profiling.
Is that the correct procedure? In other words, is the measurement step expecting a patch set that matches the patch set that was printed? That seems reasonable but thought it was worth confirming.
Assuming the saved patch set should be used, is there any reason not to use the saved patch set for all target printing in the future?
I've asked Xrite support twice but they keep answering a different question (though they were helpful on several other questions in the same case).
Thanks,
Alec
-
Yes, correct.
-
Thanks, Andrew.