Luminous Landscape Forum
Equipment & Techniques => Computers & Peripherals => Topic started by: niklasalexandersson on October 05, 2017, 05:36:23 pm
-
I have a NEC-branded x-rite i1 diplay 2 which i have connected to my NEC Spectraview reference 241. Been usin spectraview profiler (last updated about a year ago by NEC)but lately all I'm getting is error messages when i try to calibrate my monitor, and I've tried downloading applications from the x-rite website (it's a mess!) and not found anything that works.
So my question is, does anyone know of a decent calibration program for my setup since spectraview profilier stopped working, and preferably free och cheap :)
Best regards,
Niklas
-
What are the errors? You really want to use this product to drive that hardware.
Have you sent the errors to NEC support; they are usually very good!
-
... So my question is, does anyone know of a decent calibration program for my setup since spectraview profilier stopped working, and preferably free och cheap :)
Best regards,
Niklas
If you cant get "spectraview profiler" to work then try "DisplayCAL" - its open source (so free - make a donation if you want) and works with the i1 diplay 2
https://displaycal.net/
-
+1 for displaycal.
-
Care to explain what makes that hardware/software combo important?
All the best,
N.
What are the errors? You really want to use this product to drive that hardware.
Have you sent the errors to NEC support; they are usually very good!
-
Care to explain what makes that hardware/software combo important?
The software was designed from the ground up to control the hardware in the panel!
-
Ok, thanks!
The software was designed from the ground up to control the hardware in the panel!